MacDon M200 Betreibershandbuch PDF herunterladen (Seite 145)

MAINTENANCE AND SERVICING - M150 ENGINE

Form 169017 / 169087 / 169095 143 Revision C

7.8.6.2 Fuel Filters

The M150 and M200 Windrower fuel system is

equipped with primary (C) and secondary (D)

filters. Both filters are screw-on cartridge type, but

the primary (C) filter is equipped with a separator

that separates sediment and water from the fuel.

Change both filters every 500 hours of operation,

as follows:

a. Open engine compartment hood to highest

position.

b. Close fuel supply valve (E) under fuel tank.

c. Change primary filter (C) as follows:

1. Clean around the filter head (F).

2. Disconnect Water In Fuel (WIF) sensor (G)

from bottom of filter.

3. Turn drain valve (H) by hand counter

clockwise until draining occurs, and drain filter

into a container.

4. Remove filter (C) with a filter wrench.

5. Clean gasket mating surface.

6. Screw the new filter (C) onto the filter mount

until the gasket contacts the filter head.

7. Reconnect WIF sensor (G).

8. Tighten the filter an additional ½ to ¾ turn by

hand.

IMPORTANT

Do not use a filter wrench to install the filter.

Over-tightening can damage the gasket and

filter.

(continued next page)

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 233 234

Keine Kommentare

MacDon M200 Betreibershandbuch Seite 145