MacDon M200 Betreibershandbuch PDF herunterladen (Seite 205)

MAINTENANCE AND SERVICING

Form 169017 / 169087 / 169095 203 Revision C

7.13.1.4 Drive Wheel Removal/Installation

DANGER

To avoid severe personal injury or death

caused by machine runaway, shut off engine

and remove key before performing any of the

following checks and/or adjustments.

a. Remove header.

b. Park windrower on level ground, and block all

wheels.

c. Place GSL in N-DETENT, shutdown engine, and

remove key.

d. Jack up windrower under leg jack point, and raise

windrower wheel slightly off ground.

e. Undo wheel nuts (A) and remove wheel.

f. To install new tire, ensure that air valves are on

outside and tire tread point forward.

For "Turf” tires (diamond tread), be sure arrow on

sidewall points in forward rotation.

g. Position wheel on hub, and install wheel nuts (A).

h. Tighten nuts (A) to 220 ft·lbf (300 N·m) using the

tightening sequence as shown.

NOTE

To avoid damage to wheel rims, do not

over-tighten wheel nuts.

i. Repeat sequence three times.

j. Lower windrower, and remove jack.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 233 234

Keine Kommentare

MacDon M200 Betreibershandbuch Seite 205