MacDon M200 Betreibershandbuch PDF herunterladen (Seite 206)

MAINTENANCE AND SERVICING

Form 169017 / 169087 / 169095 204 Revision C

7.13.2 CASTER WHEELS

7.13.2.1 Tire Inflation

a. Visually check daily

that tires have not lost

pressure. Under-inflation of drive tires can cause

side wall cracks.

DANGER

To avoid severe personal injury or death

caused by machine runaway, shut off engine

and remove key before performing any of the

following checks and/or adjustments.

b. Measure tire pressure annually with a gauge.

Maintain the pressure at 10 psi (69 kPa).

NOTE

If caster wheels shimmy, a possible cause

is over-inflation.

DANGER

• Never install a tube in a cracked wheel rim.

• Never weld a wheel rim.

• Make sure all the air is removed from a tire

before removing the tire from the rim.

• Never use force on an inflated or partially

inflated tire. Make sure the tire is correctly

seated before inflating to operating

pressure.

• Do not remove, install or make repairs to a

tire on a rim unless you have the proper

equipment and experience to perform the

job. Take the tire and rim to a qualified tire

repair shop.

• If the tire is not in correct position on the

rim, or if too full of air, the tire bead can

loosen on one side, causing air to leak at

high speed and with great force. An air

leak of this nature can thrust the tire in any

direction, endangering anyone in the area.

• Use a safety cage if available.

• Do not stand over tire. Use a clip-on chuck

and extension hose.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 233 234

Keine Kommentare

MacDon M200 Betreibershandbuch Seite 206